How to maintain the aluminum profile extruder?

[aminaas1576]

The screw speed should be gradually increased from low to high, and the idle time of the drum should be less than 2-3 minutes.

When the screw is idling in the barrel, pay attention to the working condition of the extruder main motor.

The extruder motor should constantly monitor its working condition to avoid long-term overload and shorten its service life.

Check the connection of each part, tighten the bolts according to the standard operation and check if there is any looseness.

Each lubricated part should be checked at each malta number data session to ensure it is completely lubricated.

The temperature of the aluminum extruder bearing should not exceed 50°C.

Any residue on the screw should be cleaned off promptly.

After working every day, the residue extruded by the aluminum extruder, the packaging mold, the screws and the machine should be cleaned in time.

To prevent aluminum extruder failure, equipment maintenance is very important.

Common problems include frequent downtime (especially when there is no power) and machine failures (failures due to machine malfunctions). Let's look at how the equipment is maintained.

Daily maintenance must be observed and the machine must be kept to a certain level of cleanliness.