Finishing the doorway with extensions
Posted: Thu Feb 06, 2025 3:53 am
For construction, doors of different types can be purchased: with a frame beam, on the outside of which a groove for the extension has already been selected, with a frame without this device.
In the first case, everything happens quite simply. Chipboard or regular wooden planks with a thickness of ten millimeters will do. This thickness must be measured together with the frame installed in the doorway. And if this is done without it, it is important to remember that the extension only complements the base frame.
The distance from the end of the recess in the frame to the edge of the opening is determined. In other words, the width of the extension should be equal to the sum of the bahamas mobile database size of the recess and the width that is missing to cover the opening completely. Usually, this value is equal to one centimeter, but other options are possible.
Important! Measurements are taken in several places, for example, in four points. The readings may be different. In this case, the maximum size is considered the base size.
The fully assembled edge line of the extension itself should be level with the opening. Tiny excess is removed with a plane, later this place will be masked by the casing.
The additional extension of the door structure with a groove only remains to be nailed to the outside of the uninstalled base with small galvanized nails, the distance between which should be approximately 20-35 cm.
It is also possible to insert it into a previously glued recess in a fixed box.
If you have to work with a box beam that does not have a special recess, the contractor can do the following:
In the first case, everything happens quite simply. Chipboard or regular wooden planks with a thickness of ten millimeters will do. This thickness must be measured together with the frame installed in the doorway. And if this is done without it, it is important to remember that the extension only complements the base frame.
The distance from the end of the recess in the frame to the edge of the opening is determined. In other words, the width of the extension should be equal to the sum of the bahamas mobile database size of the recess and the width that is missing to cover the opening completely. Usually, this value is equal to one centimeter, but other options are possible.
Important! Measurements are taken in several places, for example, in four points. The readings may be different. In this case, the maximum size is considered the base size.
The fully assembled edge line of the extension itself should be level with the opening. Tiny excess is removed with a plane, later this place will be masked by the casing.
The additional extension of the door structure with a groove only remains to be nailed to the outside of the uninstalled base with small galvanized nails, the distance between which should be approximately 20-35 cm.
It is also possible to insert it into a previously glued recess in a fixed box.
If you have to work with a box beam that does not have a special recess, the contractor can do the following: